company's product

Contact: Cheng Manager Mobile Number: 15358420032
Enterprise fixed line: 0512-58554322
Customer Service QQ: 2282113449, 1514436998
Company E-mail: 2282113449@qq.com
Company Address: Sanxing Development Zone, Jinfeng Town, Zhangjiagang City, Suzhou City, Jiangsu Province, Zhangjiagang City, Jiangsu Province

news
Home > news > Hot and cold cylinder use and maintenance skills
Hot and cold cylinder use and maintenance skills
Edit:Zhangjiagang Tianbao Machinery Manufacturing Co., Ltd.   PublicDate:2018-08-03

Hot and cold cylinders are a kind of machinery commonly used in the industry, so they are also very particular about their use and maintenance. Normally, before use, the hot and cold tanks should be cleaned with fresh water and then steamed. The material slurry enters the cylinder from the material pipe fixed on the cylinder head, or the cylinder head is opened, and the material should not be packed too full, so as to prevent the material from being splashed when stirred by the agitator, resulting in unsanitary or loss of environment. Here we will give you a detailed introduction to the use and maintenance of the hot and cold cylinders :

Hot and cold cylinder use and maintenance skills

1, insulation:

According to the required temperature, start the stirrer, high-speed valve, and maintain the temperature (pay attention to the thermometer) in order to achieve the purpose of insulation.

2, cooling method:

Close the steam valve, release the remaining steam condensate from the jacket, and then open the bottom tank refrigerant valve to allow the refrigerant to pass through the jacket to reduce the temperature of the material in the cylinder.

3. Heating method:

When heating, the refrigerant inlet valve must be closed, the remaining refrigerant in the jacket should be drained, the material should be input, the stirrer should be turned on, and then the steam valve should be opened. After reaching the required temperature, the steam valve should be closed first, after 2~3 minutes, Turn off the stirrer again.

4, maintenance:

Always pay attention to the working condition of the whole set of equipment and reducer. When the reducer oil is insufficient, it should be replenished immediately. Change the oil once every half year (40# oil). When the equipment is not in use, be sure to rinse the jacket with warm water to avoid salt water corrosion. Scrub the cylinder to keep the appearance clean and the inner liner bright for durability.

The above is the use and maintenance skills of the hot and cold cylinders introduced in detail. In addition to the above, we should also pay attention to the fact that after the use of the hot and cold cylinders, the remaining condensate in the cylinder should be drained. Rinse with warm water as soon as possible, brush off the sticky material, then wash it thoroughly with 40C~50C alkaline water on the inner wall of the container, and rinse it with water. When it is next used, use hot water or steam (90C) or more, keep 2~3 Minute disinfection treatment.